Zum Inhalt springen
Elausys

KNX-Gateways für Wechselrichter / INV-KNX Fronius Benutzerhandbuch

ETS-Inbetriebnahme

Physikalische Adressierung, Applikationseinstellungen, Gruppenadressverknüpfungen und ETS-Downloads für INV-KNX Fronius.

elausys · 13 September 2026
Auf dieser Seite

Physikalische Adresse zuweisen

Add the appropriate Elausys INV-KNX application to the ETS project. Choose an unused physical address in the project topology; Press the gateway P button to enter programming mode and download the physical address.

Applikationsparameter einstellen

Once a KNX physical address is set, open the parameter tab to configure the interface.

Select the type of AC network (single phase or tri-phase).

Set the inverter model to 3 for Fronius inverters or 6 for Fronius Symo Hybrid inverters.

Choose the refresh rate (min) for the complete set of data.

Select if battery 1 is available on the inverter.

Select Powermeter if a Fronius Smart Meter is available.

Fronius Smart meter modbus ID must be set in the “Device Options” field.

Smartmeter ID must be checked in the inverter configuration (default is 200 or 240).

Set the timezone and daylight-saving option when using weekly calendar logic. See Section 6 for the full parameter values and limitations.

Objekte verknüpfen und Applikation herunterladen

A group address (GA) must be assigned to each group object (GO) needed by the application.

Open the Group Objects tab of the device and assign a GA to the objects as needed.

When GO and parameters are all configured, download the KNX Interface application to the device. The first download requires to press the programming button on the device to set the device in KNX programming mode then perform a full download.

Ergebnis prüfen

Use ETS Group Monitor to check module status, read the firmware version and compare live measurements with the inverter. Follow Section 7 before enabling automation.

ETS-Software

The gateway is configured with ETS from the KNX Association. ETS Demo supports projects of up to five KNX modules; the gateway occupies one module.

All chapters of the INV-KNX Fronius user manual

Häufig gestellte Fragen

Was ist für den ersten ETS-Download erforderlich?

Weisen Sie die physikalische Adresse über die P-Taste im Programmiermodus zu. Konfigurieren Sie die Applikationsparameter und Gruppenadressverknüpfungen und führen Sie anschließend einen vollständigen Download durch.

Was sollte ich nach dem Download der Applikation prüfen?

Verwenden Sie ETS Group Monitor, um Modulstatus und Firmware zu lesen, und vergleichen Sie die Live-Messwerte nach dem Abfrageintervall mit dem Wechselrichter.

Weiter erkunden

Finden Sie die weiteren Anleitungen zu diesem Produkt in der Dokumentation.

Zurück zu INV-KNX Fronius Benutzerhandbuch