Zum Inhalt springen
Elausys

KNX-Gateways für Wechselrichter / INV-KNX Fronius Benutzerhandbuch

Schnelle Inbetriebnahme

Die Inbetriebnahmesequenz für INV-KNX Fronius, von der Verkabelung bis zu geprüften KNX-Messwerten.

elausys · 10 September 2026
Auf dieser Seite

Follow these steps in order. Use the detailed sections for model-specific settings and the complete object reference.

1 Installation vorbereiten

Have the gateway, KNX bus connection, 12-30 VDC auxiliary supply, network connection, ETS application and inverter configuration access ready. Check compatibility and firmware in Sections 3 and 10.

2 Gateway anschließen und mit Spannung versorgen

Connect KNX at the top. Connect auxiliary power and RJ45 Ethernet at the bottom. Connect the equipment to the same local network. The green Network LED confirms the Ethernet link; see Section 3.

3 Wechselrichterverbindung konfigurieren

Enable Modbus TCP or configure the required inverter connection using Section 4. Confirm the inverter address, port and Unit ID.

4 Gateway-Netzwerk und Modbus-Verbindung einstellen

Open 192.168.1.51 from a laptop on a compatible network and assign an appropriate fixed gateway IP address. Set Mode to Connect, Server IP to the inverter address, Server Port to 502 and Unit ID to 1.

5 KNX-Gerät in ETS konfigurieren

Assign a free physical address. Set Inverter model to 3 for Fronius including Gen24; 6 for Fronius Symo Hybrid. Set the AC network, applicable PV circuits, refresh rate and available equipment. Set Device Options to the Fronius Smart Meter Modbus ID when a meter is installed; check the actual ID (default 200 or 240). See Sections 5 and 6.

6 Gruppenadressen verknüpfen und herunterladen

Assign group addresses to the required objects. Press P when ETS requires programming mode and perform a full application download for initial commissioning. See Section 5.

7 Daten prüfen und Logik aktivieren

Check the Connected LED and Module status (GO 1 = 0). Read firmware (GO 2), wait for the polling interval and compare live values with the inverter. Check power directions and optional equipment before enabling logic. See Section 7.

Commissioning is complete when

The network and inverter links are established, the ETS download succeeds, and the required group objects return plausible values for the installed equipment.

All chapters of the INV-KNX Fronius user manual

Häufig gestellte Fragen

Was muss vor der Inbetriebnahme bereit sein?

Bereiten Sie Gateway, 12–30 VDC-Hilfsversorgung, KNX-Bus, Netzwerkanschlüsse, ETS-Applikation und Zugriff auf die Wechselrichterkonfiguration vor.

Beweist die Network-LED, dass die Inbetriebnahme abgeschlossen ist?

Nein. Die Network-LED bestätigt die Ethernetverbindung. Prüfen Sie Connected, schließen Sie den ETS-Download ab und vergleichen Sie die KNX-Werte mit dem Wechselrichter.

Wann soll die Automatisierung aktiviert werden?

Prüfen Sie Modulstatus, Abfrageintervall, Live-Messwerte, Leistungsrichtungen und die Verfügbarkeit optionaler Geräte.

Weiter erkunden

Finden Sie die weiteren Anleitungen zu diesem Produkt in der Dokumentation.

Zurück zu INV-KNX Fronius Benutzerhandbuch