Naar de inhoud
Elausys

KNX Gateways voor Omvormers / INV-KNX Fronius Gebruikershandleiding

Groepsadressen en gegevensvalidatie

Inbedrijfstellingscontroles en interpretatie van KNX-metingen die door INV-KNX Fronius worden geleverd.

elausys · 15 september 2026
Op deze pagina

A group object (GO) is a device datapoint. A group address (GA) links it to other KNX devices or a visualisation. Assign group addresses only to the objects needed by the project and match their datatypes to Section 8.

Controles bij de inbedrijfstelling

GOObjectWhat to check
1Module status0 means normal operation; investigate a non-zero status.
2Firmware versionRead the version and check the applicability in Section 11.
24AC PowerCompare the value with the inverter display or application.
30AC EnergyCompare the accumulated value and units.
42 / 43Battery power / SOCWhere supported, enable Battery 1 and compare with the battery state.
55PowermeterWhere supported, enable the meter and verify the measurement direction.

Vermogensrichtingen en beschikbaarheid controleren

GO 40 Daily Energy Yield: (NOT USED)

GO 41 Battery 1 Running Status: 0: OFF 1: EMPTY 6: DISCHARGING 7: CHARGING 9: FULL 10: HOLDING 11: TESTING

GO 42 Battery 1 power: (NOT USED)

GO 49 Battery 2 power: (NOT USED)

GO 55 Powermeter: Fronius Smart meter (meter modbus ID must be set in the ETS parameter Options)

Niet-beschikbare objecten

Objects marked NOT USED are unavailable for this application even when the generic ETS interface exposes them. Check equipment and operating conditions before treating zero values as a fault.

Alle hoofdstukken van de INV-KNX Fronius-handleiding

Veelgestelde vragen

Wat is het verschil tussen een groepsobject en een groepsadres?

Een groepsobject is een datapunt van een apparaat. Een groepsadres koppelt dit aan andere KNX-apparaten of visualisatie. Wijs adressen toe aan de benodigde objecten en gebruik de juiste datatypes.

Wijst een meting van nul altijd op een fout?

Nee. Controleer bedrijfsomstandigheden en apparatuur voordat u nul als communicatiefout beschouwt. Wacht ook het ingestelde pollinginterval af.

Is Fronius Battery 1 power beschikbaar?

GO 42 Battery 1 power is voor deze applicatie gemarkeerd als NOT USED. Het inschakelen van het generieke object maakt de meting niet beschikbaar.

Verder verkennen

Vind de andere handleidingen voor dit product in de documentatie.

Terug naar INV-KNX Fronius Gebruikershandleiding