Saltar para o conteúdo
Elausys

Portas KNX para Inversores / Manual do Utilizador INV-KNX Fronius

Colocação em serviço ETS

Endereçamento físico, definições da aplicação, ligações de endereços de grupo e transferências ETS para a INV-KNX Fronius.

elausys · 13 setembro 2026
Nesta página

Atribuir o endereço físico

Add the appropriate Elausys INV-KNX application to the ETS project. Choose an unused physical address in the project topology; Press the gateway P button to enter programming mode and download the physical address.

Definir os parâmetros da aplicação

Once a KNX physical address is set, open the parameter tab to configure the interface.

Select the type of AC network (single phase or tri-phase).

Set the inverter model to 3 for Fronius inverters or 6 for Fronius Symo Hybrid inverters.

Choose the refresh rate (min) for the complete set of data.

Select if battery 1 is available on the inverter.

Select Powermeter if a Fronius Smart Meter is available.

Fronius Smart meter modbus ID must be set in the “Device Options” field.

Smartmeter ID must be checked in the inverter configuration (default is 200 or 240).

Set the timezone and daylight-saving option when using weekly calendar logic. See Section 6 for the full parameter values and limitations.

Ligar objetos e transferir a aplicação

A group address (GA) must be assigned to each group object (GO) needed by the application.

Open the Group Objects tab of the device and assign a GA to the objects as needed.

When GO and parameters are all configured, download the KNX Interface application to the device. The first download requires to press the programming button on the device to set the device in KNX programming mode then perform a full download.

Verificar o resultado

Use ETS Group Monitor to check module status, read the firmware version and compare live measurements with the inverter. Follow Section 7 before enabling automation.

Software ETS

The gateway is configured with ETS from the KNX Association. ETS Demo supports projects of up to five KNX modules; the gateway occupies one module.

Todos os capítulos do manual INV-KNX Fronius

Perguntas frequentes

O que é necessário para a primeira transferência ETS?

Atribua o endereço físico utilizando o botão P para o modo de programação. Configure os parâmetros da aplicação e as ligações de endereços de grupo necessárias e faça uma transferência completa.

O que devo verificar depois de transferir a aplicação?

Utilize o ETS Group Monitor para ler o estado do módulo e o firmware e compare as medições em tempo real com o inversor após o intervalo de consulta.

Continuar a explorar

Encontre os outros guias deste produto na documentação.

Voltar a Manual do Utilizador INV-KNX Fronius