Saltar para o conteúdo
Elausys

Portas KNX para Inversores / Manual do Utilizador INV-KNX Fronius

Endereços de grupo e validação de dados

Commissioning checks and interpretation of KNX measurements supplied by INV-KNX Fronius.

elausys · 15 setembro 2026
Nesta página

A group object (GO) is a device datapoint. A group address (GA) links it to other KNX devices or a visualisation. Assign group addresses only to the objects needed by the project and match their datatypes to Section 8.

Commissioning checks

GOObjectWhat to check
1Module status0 means normal operation; investigate a non-zero status.
2Firmware versionRead the version and check the applicability in Section 11.
24AC PowerCompare the value with the inverter display or application.
30AC EnergyCompare the accumulated value and units.
42 / 43Battery power / SOCWhere supported, enable Battery 1 and compare with the battery state.
55PowermeterWhere supported, enable the meter and verify the measurement direction.

Check power directions and availability

GO 40 Daily Energy Yield: (NOT USED)

GO 41 Battery 1 Running Status: 0: OFF 1: EMPTY 6: DISCHARGING 7: CHARGING 9: FULL 10: HOLDING 11: TESTING

GO 42 Battery 1 power: (NOT USED)

GO 49 Battery 2 power: (NOT USED)

GO 55 Powermeter: Fronius Smart meter (meter modbus ID must be set in the ETS parameter Options)

Unavailable objects

Objects marked NOT USED are unavailable for this application even when the generic ETS interface exposes them. Check equipment and operating conditions before treating zero values as a fault.

Manual navigation

All chapters of the INV-KNX Fronius user manual

Perguntas frequentes

Qual é a diferença entre um objeto de grupo e um endereço de grupo?

Um objeto de grupo é um ponto de dados do dispositivo. Um endereço de grupo liga-o a outros dispositivos KNX ou a uma visualização.

Uma medição zero indica sempre uma falha?

Não. Verifique as condições de funcionamento e a disponibilidade do equipamento antes de considerar zero uma falha.

A potência de Battery 1 está disponível?

GO 42 Battery 1 power está marcado como NOT USED para esta aplicação.

Continuar a explorar

Encontre os outros guias deste produto na documentação.

Voltar a Manual do Utilizador INV-KNX Fronius