Vai al contenuto
Elausys

Gateway KNX per Inverter / Manuale utente INV-KNX Fronius

Indirizzi di gruppo e convalida dei dati

Commissioning checks and interpretation of KNX measurements supplied by INV-KNX Fronius.

elausys · 15 settembre 2026
In questa pagina

A group object (GO) is a device datapoint. A group address (GA) links it to other KNX devices or a visualisation. Assign group addresses only to the objects needed by the project and match their datatypes to Section 8.

Commissioning checks

GOObjectWhat to check
1Module status0 means normal operation; investigate a non-zero status.
2Firmware versionRead the version and check the applicability in Section 11.
24AC PowerCompare the value with the inverter display or application.
30AC EnergyCompare the accumulated value and units.
42 / 43Battery power / SOCWhere supported, enable Battery 1 and compare with the battery state.
55PowermeterWhere supported, enable the meter and verify the measurement direction.

Check power directions and availability

GO 40 Daily Energy Yield: (NOT USED)

GO 41 Battery 1 Running Status: 0: OFF 1: EMPTY 6: DISCHARGING 7: CHARGING 9: FULL 10: HOLDING 11: TESTING

GO 42 Battery 1 power: (NOT USED)

GO 49 Battery 2 power: (NOT USED)

GO 55 Powermeter: Fronius Smart meter (meter modbus ID must be set in the ETS parameter Options)

Unavailable objects

Objects marked NOT USED are unavailable for this application even when the generic ETS interface exposes them. Check equipment and operating conditions before treating zero values as a fault.

Manual navigation

All chapters of the INV-KNX Fronius user manual

Domande frequenti

Qual è la differenza tra un oggetto di gruppo e un indirizzo di gruppo?

Un oggetto di gruppo è un punto dati del dispositivo. Un indirizzo di gruppo lo collega ad altri dispositivi KNX o a una supervisione.

Una misura pari a zero indica sempre un guasto?

No. Verifica le condizioni operative e la disponibilità dell'apparecchiatura prima di considerare lo zero un guasto.

La potenza di Battery 1 è disponibile?

GO 42 Battery 1 power è contrassegnato come NOT USED per questa applicazione.

Continua a esplorare

Trova le altre guide per questo prodotto nella documentazione.

Torna a Manuale utente INV-KNX Fronius