Μετάβαση στο περιεχόμενο
Elausys

KNX Πύλες για Inverters / Εγχειρίδιο χρήσης INV-KNX Fronius

Διευθύνσεις ομάδας και επικύρωση δεδομένων

Commissioning checks and interpretation of KNX measurements supplied by INV-KNX Fronius.

elausys · 15 Σεπτεμβρίου 2026
Σε αυτή τη σελίδα

A group object (GO) is a device datapoint. A group address (GA) links it to other KNX devices or a visualisation. Assign group addresses only to the objects needed by the project and match their datatypes to Section 8.

Commissioning checks

GOObjectWhat to check
1Module status0 means normal operation; investigate a non-zero status.
2Firmware versionRead the version and check the applicability in Section 11.
24AC PowerCompare the value with the inverter display or application.
30AC EnergyCompare the accumulated value and units.
42 / 43Battery power / SOCWhere supported, enable Battery 1 and compare with the battery state.
55PowermeterWhere supported, enable the meter and verify the measurement direction.

Check power directions and availability

GO 40 Daily Energy Yield: (NOT USED)

GO 41 Battery 1 Running Status: 0: OFF 1: EMPTY 6: DISCHARGING 7: CHARGING 9: FULL 10: HOLDING 11: TESTING

GO 42 Battery 1 power: (NOT USED)

GO 49 Battery 2 power: (NOT USED)

GO 55 Powermeter: Fronius Smart meter (meter modbus ID must be set in the ETS parameter Options)

Unavailable objects

Objects marked NOT USED are unavailable for this application even when the generic ETS interface exposes them. Check equipment and operating conditions before treating zero values as a fault.

Manual navigation

All chapters of the INV-KNX Fronius user manual

Συχνές ερωτήσεις

Ποια είναι η διαφορά μεταξύ αντικειμένου ομάδας και διεύθυνσης ομάδας;

Ένα αντικείμενο ομάδας είναι σημείο δεδομένων της συσκευής. Μια διεύθυνση ομάδας το συνδέει με άλλες συσκευές KNX ή οπτικοποίηση.

Υποδεικνύει πάντα μια μηδενική μέτρηση βλάβη;

Όχι. Ελέγξτε τις συνθήκες λειτουργίας και τη διαθεσιμότητα του εξοπλισμού πριν θεωρήσετε το μηδέν σφάλμα.

Είναι διαθέσιμη η ισχύς Battery 1;

Το GO 42 Battery 1 power σημειώνεται ως NOT USED για αυτή την εφαρμογή.

Συνεχίστε την εξερεύνηση

Βρείτε τους υπόλοιπους οδηγούς για αυτό το προϊόν στην τεκμηρίωση.

Επιστροφή στο Εγχειρίδιο χρήσης INV-KNX Fronius