Saltar al contenido
Elausys

Puertas KNX para Inversores / Manual de usuario INV-KNX Fronius

Referencia de parámetros ETS

Tabla completa de parámetros ETS e indicaciones específicas de la aplicación para INV-KNX Fronius.

elausys · 14 septiembre 2026
En esta página

These parameters are in the device Parameters tab. Apply the settings and availability limits for this inverter family.

ParameterValuesFronius configuration guidance
AC NetworkSingle phase (default) Tri-PhaseType of AC network
Number of PV Circuits1 … 4NOT APPLICABLE for this type of inverters
Inverter model0…2553 = Fronius Inverters (Gen24,…) 6 = Fronius Symo Hybrid
Refresh rate (min)0…255Cyclic rate of data polling from the inverter.
Battery 1Not Used / UsedDisplay group objects to monitor the status of battery 1
Battery 2Not Used / UsedDisplay group objects to monitor the status of battery 2 (NOT USED for this inverter)
PowermeterNot Used / UsedDisplay group objects to monitor the powermeter value
TimezoneUTC-11… UTC+14Timezone where the device is installed. It is used for logic functions based on the weekly calendar.
Daylight saving timeNot Used / UsedSet if daylight saving is used where the device is installed. It is used for logic functions based on the weekly calendar.
Device OptionsText stringFronius Smart meter modbus ID (if available)

Configuración de la aplicación

Set Device Options to the Fronius Smart Meter Modbus ID when a meter is installed; check the actual ID (default 200 or 240).

An enabled object does not make an unsupported measurement available. Check the complete object reference in Section 8.

Intervalo de consulta

Allow the configured polling interval before checking that measurements update. Choose the interval required for the KNX project.

Todos los capítulos del manual INV-KNX Fronius

Preguntas frecuentes

¿Qué modelo de inversor debo seleccionar?

Seleccione el modelo 3 para inversores Fronius, incluido Gen24, o el modelo 6 para Fronius Symo Hybrid.

¿Qué debo introducir en Device Options?

Introduzca el ID Modbus del Fronius Smart Meter cuando haya un contador instalado. Compruebe el ID real en la configuración del inversor; los valores predeterminados documentados son 200 o 240.

¿Activar un objeto opcional garantiza una medición?

No. El modelo de inversor seleccionado y el equipo instalado deben proporcionar esa medición. Consulte la tabla de disponibilidad de objetos de comunicación.

Seguir explorando

Encuentre las demás guías de este producto en la documentación.

Volver a Manual de usuario INV-KNX Fronius