Skip to content
Elausys

KNX Gateways for Alarm Systems / AJAX-KNX User Manual

Connections and front panel

Power, KNX and Ethernet connections, plus the meaning of the front-panel indicators.

elausys · 12 September 2026
On this page

Connection Diagram

The KNX bus is connected on the top side of the gateway. An external power supply (12–30 VDC) is required and connected on the bottom side of the module, beside the RJ45 connector for the Ethernet cable.

The gateway reaches the Ajax system in one of two ways (see Configuring the alarm system): through a secured cloud connection to Ajax (default, internet required), or by local SIA reports sent by the hub over the local network.

Network requirements

ConnectionDirectionNeeded for
TCP 7443OutgoingCloud connection to Ajax
TCP 80OutgoingAutomatic firmware updates (optional)
Local TCP 2410Incoming, from the hubLocal SIA only
Local TCP 443 and 80Incoming, from your PCWeb interface

The gateway opens the outgoing connections itself: no port forwarding is needed on the router. On a network that filters outgoing traffic (company or managed building networks), allow these connections, as well as DNS (UDP 53) and time synchronisation (NTP, UDP 123).

Front Panel

ajax-knx-front-panel.png

The front panel is equipped with two green status LEDs:

LEDMeaning
NetworkPhysical connection to the Ethernet network is established
ConnectedCommunication with the Ajax system is established: cloud connection up and hub online, or SIA reports received (local SIA)

Additional front panel elements:

ElementFunction
Button “P”KNX programming mode button. Pressed 4 times within 30 seconds: factory reset (see Firmware)
Red LEDKNX programming status LED

Frequently Asked Questions

What power supply does the gateway require?

Connect an external 12-30 VDC supply to the bottom screw terminal beside the Ethernet connector.

Do I need to open a port on the router?

No. The gateway opens its connection to the cloud itself (outgoing TCP 7443), so no port forwarding is needed. Only a network that filters outgoing traffic must allow TCP 7443, DNS and NTP.

What do the Network and Connected LEDs indicate?

Network confirms the physical Ethernet link. Connected confirms communication with the Ajax system: cloud connection up and hub online, or SIA reports received with local SIA.

Keep exploring

Find the other guides for this product in the documentation.

Back to AJAX-KNX User Manual