Skip to content
Elausys

KNX Gateways for Alarm Systems / AJAX-KNX User Manual

Introduction

Purpose, main features and supported AJAX alarm systems for the KNX gateway.

elausys · 11 September 2026
On this page

The KNX gateway module AJAX-KNX is a bidirectional KNX gateway for AJAX alarm systems. It brings the status of the alarm system to KNX in real time and lets you arm and disarm it from KNX, bridging one of the fastest-growing alarm platforms in Europe with the KNX building automation ecosystem.

It allows integrators to take advantage of a fully integrated alarm system including KNX scenario recall, arming/disarming or monitoring the system using any KNX visualization, touch panel, or push-button.

Main Features

  • Control up to 4 areas (arm / partial arm / disarm)
  • Status feedback per area: disarmed, armed, partial armed, exit delay, fire, panic, intrusion
  • Automatic recall of KNX scenes for each area status
  • Up to 96 zone statuses (when armed, in Night Mode or for Always Active zones)
  • Battery and AC failure monitoring
  • Up to 32 programmable outputs (PG): control of Ajax relays and sockets, camera events status (person, vehicle, pet…)
  • Up to 16 virtual inputs: panic alarm or photo on demand, from KNX
  • Two connections to the alarm system: secured cloud connection to Ajax, or local SIA (no internet)
  • Web interface protected by a password and encrypted (HTTPS)
  • Automatic firmware updates
  • Galvanic insulation from the KNX bus
  • DIN rail mounted (2 SU)
  • Auxiliary power supply 12–30 VDC

ETS Application Concept

The AJAX-KNX Gateway follows the exact same ETS application concept for all alarm gateways. The parameter structure, group objects, and commissioning workflow are consistent across all models. The AJAX gateway uses the NXG-KNX Interface application program.

Compatible AJAX Systems

The AJAX-KNX Gateway is compatible with all AJAX Hub, Hub Plus, and Hub 2 models.

Frequently Asked Questions

How many areas and detectors can the gateway handle?

The gateway supports up to four areas and 96 zone or detector statuses per gateway.

Do alarm events and control commands use the same connection?

With the secured cloud connection to Ajax (default), events and commands use the same connection and every feature is available; internet access is required. With local SIA, the hub sends its events over the local network without internet, but areas cannot be armed or disarmed from KNX and PG and virtual inputs are not available.

Keep exploring

Find the other guides for this product in the documentation.

Back to AJAX-KNX User Manual