The KNX interface module JA-KNX is a KNX gateway for the Jablotron 100 alarm systems. It enables bidirectional communication with the alarm system using the RS485 communication module (JA-121T) from Jablotron.
It allows integrators to take advantage of a fully integrated alarm system including KNX scenarios, automatic lighting using the motion detectors, arming or monitoring the system using a KNX visualization.
Main features:
- KNX Interface for Jablotron 100 alarm systems
- Up to 32 bidirectional input/output (PG)
- Status of each zone in real time
- Control up to 4 areas (arm/partial/disarm)
- 9 statuses per area (intrusion, entry, exit, fire,…)
- Recall of KNX scenes for each status
- Built-in termination resistor for RS485
- Communication fault monitoring
- Galvanic insulation from the KNX bus
- RX/TX communication status LED
- Optional DIN-Rail housing
Requirements
Jablotron 100 alarm panel, JA-121T RS485 module, external 12 VDC supply and KNX bus.
Use ETS with the appropriate Elausys alarm gateway application to assign the physical address, set parameters and link group addresses.
Operating limits
Virtual inputs, power supply status and Device Options are not available. Select up to 96 zone status objects using an offset of 0 or 96. See ETS parameter reference. The alarm service mode disables the interface.