This interface is intended to be used with a JABLOTRON 100 series alarm system. The system must be equipped with a JA121T module for RS485 communication.
The gateway can be mounted directly inside the alarm system panel or on an external DIN-rail using the optional housing.
NOTE: When a user is logged in to service mode on the alarm system, the RS485 and KNX interface are disabled.
Connections
Elausys JA-KNX is galvanically isolated from the KNX bus, therefore the 12VDC power supply should be provided by an external power supply or from the alarm system itself, to the J121T module output and to the JA-KNX gateway.
The RS485 bus must be interconnected between the JA121T and the JA-KNX interface. The RS485 termination resistor is already integrated on the KNX interface module, therefore no additional component or wiring is required. The JA121T module must be configured at 9600 baud.
Terminal block connection:
