Firmware version and update
This manual and the related ETS application apply to firmware V3.2.3.1 and above. Read the firmware version in the top-right corner of the gateway webpage or read GO 2 in ETS.
If Elausys provides updated firmware for this device, open FW Update on the gateway webpage, select the supplied binary file and press Update. After updating, read the firmware version again and repeat the communication and measurement checks in Section 7.
Technical data
| Specification | Value |
|---|---|
| Auxiliary supply | 12-30 VDC / GND, screw terminal |
| KNX bus current | < 16 mA at 29 VDC, typical |
| Operating temperature | +5 °C to +45 °C |
| Enclosure width | 2 space units (2 modules) |
| Mounting | DIN rail |
| KNX terminal | Pluggable red/black micro terminal, 4-pole PUSH WIRE; solid conductor wire 0.6-0.8 mm² as stated in the source |
| KNX bus voltage | 29 VDC |
Product information and support: elausys.com. Related document: KNX Logic Module User Manual. SMA configuration reference: Sunny Explorer user manual or the manual for the installed inverter.